Pro Series Case

Pro Series Case
With you, the serious racer in mind, we have designed and machined the ultimate engine case. The case is cast of 356-T6 aluminum. The castings are flawless, with zero porosity, which makes the strongest possible part. Prototype cases were X-rayed from six sides by an independent lab and received an aircraft spec.

Some of the outstanding features include:

• Four parts: two case halves, a front cover and a rear engine plate
• Case halves located with six hardened and ground dowel pins
• Two oil scavenge pick-ups
• Cast-in windage tray
• Lower bolt-in windage tray
• Machined for a future internal rev-kit
• Heavier deck surface
• Stronger cylinder stud mounting
• Thicker main bearing webs
• Case is a dry or wet sump configuration
• Ready for either a two stage or three stage dry or wet sump system
• Bolt on push rod tube seal plates with O-rings to seal
• Six stud holes per cylinder, drilled and tapped
• Front cover is a bolt-on component part and an O-ring seal for the main oil galley
• Front cover can be easily removed for access to the camshaft gear
• Ability to change your cam timing without splitting the case halves
• Front cover has two hold down holes for the magneto mount
• Rear engine plate is doweled for location
• Rear engine plate is fastened with nine allen head cap screws
• O-ring seals for both main oil galley and camshaft
• Main studs are made of chrome moly steel
• Main studs are a thru bolt design with special thick washers and aircraft nuts
• Head studs have a ground finish, double heat treat

Price:  $2,195.00